我们热爱生命科学!-生物行
当前位置: 主页 > English > Technology > Methods > PCR

3RACE PCR

时间:2005-07-18 00:00来源:Scienceboard.net 作者:admin 点击: 465次
Tuesday, November 18, 2003

Description
3' Rapid Amplification of cDNA Ends (RACE) PCR
This technique is used to obtain the 3'end of a cDNA, it requires some sequence information internal to the mRNA under study. The sequence information obtained from this technique can be utilised to obtain full length cDNA clones using the 5'RACE technique.



Procedure
1. Place approx. 1ug of total RNA (~10ng polyA RNA) in an RNase-free eppendorf, make up to 10ul with pure water. Add 1ul of T17AP (0.5ug/ul).

2. Heat this to 70C for 10 minutes, then place on ice for 5 minutes.

3. Spin pulse the tube and then add the following reagents:

4ul 5X SuperScript RTase buffer
2ul 100mM DTT
1ul 2.5mM dNTPs
1ul RNase inhibitor
1ul SuperScript RTase.

4. Mix and incubate at 37C for 2 hours.

5. Use a serial dilution of the reverse transcription reaction: 2ul of undiluted cDNA, 2ul of 10 x diluted cDNA and 2ul of 100 x diluted cDNA in the PCR reaction. Set up the PCR as follows:

35.5ul pure water
5ul 10 x PCR buffer (Boehringer Mannheim)
5ul 500uM dNTPs (some enzymes require a higher concentration of dNTPs (2mM), for example Pfu polymerase (though I'd recommend against the use of this enzyme)
1ul Adapter primer (25uM)
1ul Gene specific primer (25uM)
2ul cDNA template (various dilutions)

6. Mix and overlay with mineral oil.

7. Perform the following PCR cycles:

a. 94C 3 minutes
b. 72C 3 minutes (at this point add 0.5ul of Taq polymerase)
c. 94C 30 seconds
d. 56C* 1 minute
e. 72C 2 minutes (longer if expected fragment size is greater than 2kb)
f. Cycle steps c. - e. 35 times
g. 72C 10 minutes.

* Varies according to the melting temperature of your gene specific primer. The annealing temperature in the PCR may require some adjustment for optimal yield of PCR product.

8. Load all or part of the reaction on an agarose gel. Don't be too surprised if you get a faint background smear as well as your prominent band.



Recipes
Sterile water (high purity, RNase-free)
5 x SuperScript RTase buffer (Life Technologies)
100mM DTT
2.5mM dNTPs
RNase inhibitor (Pharmacia)
SuperScript RTase (Life Technologies)
10 x PCR buffer (Boehringer Mannheim, contains 15mM MgCl2)
500mM dNTPs
Mineral oil
RNA : Both total and polyA RNA are suitable for this technique. I recently compared the two and found the polyA RNA reaction to have the edge, but only just. I do recommend using polyA RNA for 5'RACE though.
Primers:-
T17 Adapter primer (T17AP): GACTCGAGTCGACATCGATTTTTTTTTTTTTTTTT
Adapter primer (AP): GACTCGAGTCGACATCG
Gene specific primer: Designed from known sequence, ideally it should an 18-22-mer with an annealing temperature of around 56C, where a G/C = 4C and an A/T = 2C.



Supplies


Tips

(责任编辑:泉水)
顶一下
(0)
0%
踩一下
(0)
0%
------分隔线----------------------------
发表评论
请自觉遵守互联网相关的政策法规,严禁发布色情、暴力、反动的言论。
评价:
表情:
用户名: 验证码:点击我更换图片